MX Atmos Energy, Инструкция по монтажу

Страница: 9 / 16

CAUTION
Check there are no hidden cables or pipes before drilling holes for wall plugs.
Exercise great care when using power tools near water.
The use of a residual current device (RCD) is recommended.
!

!
!

!
11. FITTING THE VERTICAL RAIL AND HANDSET
1. Assemble the exposed mixer valve, fit the diverter
valve to the mixer valve making sure sealing washer
is fitted (Fig 1).
2. Loosely attach the vertical rail to the diverter valve
and mark the position for the fixed bracket. You may
wish to fit the shorter wall bracket connector to
allow the rail to fit closer to the wall (Fig 2).
NOTE: Ensure the rail is vertically above the mixer
valve using a spirit level.
3. Ensure there are no cables or pipework behind the
wall bracket position. Remove the vertical rail and
position the wall bracket in the marked position.
Mark the 3 hole positions for the screws. Drill and
plug the wall (The wall plugs are suitable for most
brick walls - use an appropriate masonry drill, but
if the wall is plasterboard or a soft building block,
use suitable wall plugs and a suitable drill bit, not
supplied).
4. Secure the bracket mounting plate to the wall then
push on the bracket cover.
5. Take the 10mm key (supplied) and insert into the
hexagon hole in the bottom of the vertical rail,
unscrew brass threaded insert to remove the
components by turning in a clockwise direction
(Fig 3).
NOTE: This is a left hand thread.
6. With the lever on the right hand side and pointing
down, slide the handset height adjuster onto the
vertical rail and lock in place then slide on the hose
retaining ring (Fig 4).
1
2
3
4
TIPS
• A piece of insulating or masking tape applied
to the wall before marking out the fixing
holes will help stop the drill from wandering,
particularly on tiled surfaces.
!

!