MX Atmos Azure, Инструкция по монтажу

Страница: 8 / 16

CAUTION
Check there are no hidden cables or pipes before drilling holes for wall plugs.
Exercise great care when using power tools near water.
The use of a residual current device (RCD) is recommended.
!

!
!

!
9. FITTING THE VERTICAL RAIL AND HANDSET
1. Assemble the diverter valve to the mixer valve
making sure sealing washer is fitted and the outlet
is pointing upwards (Fig 1).
2.
Attach the vertical rail to the diverter valve and
mark the position for the fixed bracket. Ensure the
rail is vertically above the valve using a spirit level
(Fig 2).
3.
Ensure there is no cables or pipework behind the
wall bracket position. Remove the vertical rail and
position the wall bracket in the marked position.
Mark the 3 hole positions for the screws. Drill and
plug the wall (The wall plugs are suitable for most
brick walls - use an appropriate masonry drill. If
the wall is plasterboard or a soft building block, use
suitable wall fixings and a drill bit, not supplied).
4. Take the supplied allen key and insert into the
hexagon hole in the bottom of the vertical rail,
unscrew brass threaded insert to remove the
components by turning in a clockwise direction
(Fig 3).
NOTE: This is a left hand thread.
5. Fit the height adjuster and the hose retaining ring
on to the vertical rail (Fig 4). Replace the revolving
nut by screwing the brass threaded into the vertical
rail ensuring the rubber o-ring seal is in place.
Hand tighten using the allen key.
6. The vertical rail is telescopic, unscrew the locking
nut being careful not to damage the chrome plating.
Slide the inner tube out from the outer one to the
required length (Fig 5).
1
2
3
5
4
TIPS
• A piece of insulating or masking tape applied
to the wall before marking out the fixing
holes will help stop the drill from wandering,
particularly on tiled surfaces.
!

!