RAPID CHANGE WEIGHT SYSTEMS
RAPID CHANGE
WEIGHT SYSTEMS
[email protected] www.mxselect.com
SELECT
4
CORRECT SPACING
CORRECT SPACING
Weight plates have a thin gap
but don’t move freely
CRADLE SPACING TOO WIDE
Weight plates move freely
when in Cradle
CRADLE SPACING TOO CLOSE
Cant remove weights and
selector dial won’t turn
IF CRADLE SPACING
TOO WIDE
IF CRADLE SPACING
TOO CLOSE
Push the floating Cradle end slightly inwards. Tighten Bolts and replace MX Dumbbell Handset and check
that the gap between the plates is the correct spacing and test on all dial settings. If not correct, repeat
adjustment steps.
Move slightly apart the floating Cradle end outwards, opening a slight gap between the plates. Tighten bolts
and replace MX Dumbbell Handset check that the gap between the plates is the correct spacing and test on all
dial settings. If not correct, repeat adjustment steps.
---------------------
Remove MX Dumbbell Handset and turn the Cradle over. Using an M4 Allen Key remove the Cradle
Feet Bolts and Cradle Feet to gain access to the Cradle adjustments Bolts.
---------------------
Using an M4 Allen Key loosen the Cradle Adjustment Bolts at one end of the Cradle just
enough to allow you to move the Cradle inwards or outwards as required.
STEP ONE
STEP TWO
M4 ALLEN KEY
STEPS TO RESOLVE THE FOLLOWING
+ Selector dial will not push down and lock into place
+ Selector dial feels tight or will not turn
+ Extra weight plate sticks when the MX Dumbbell Handset is removed from Cradle
+ Weight plates are too widely spaced or too closely spaced
FOR SMOOTH & ACCURATE WEIGHT PLATE SELECTION
Adjustment bolts
in slotted holes
MX DUMBBELL ADJUSTMENT GUIDE
