MX Options Solo QI, Руководство по установке

Страница: 9 / 13

11. OPERATING THE SHOWER
1. Switch on pull-cord or wall mounted switch.
2. Turn the power selector knob to the cold
setting
•
for immediate water fl ow.
3. Select your power setting using the top
control. The shower has three positions
COLD
•
, ECO and FULL
•
power.
COLD
•
setting (Solid Blue Symbol):
Adjustment of the fl ow control on this setting
will only alter the fl ow of water not the water
temperature.
ECO
settings (Open Red Symbol):
This is the low power setting for economy
during warmer months or when a cool
shower is required. Temperature adjustment
is via the bottom temperature control.
FULL
•
setting (Solid Red Symbol):
This is the full power setting. Temperature
adjustment is via the bottom temperature
control.
4. Wait a few seconds for the warmer water to
reach the showerhead.
5. If necessary turn bottom ‘Temperature’
control knob slowly to obtain desired
showering temperature. Again, waiting
a few seconds after each adjustment in
temperature to reach the showerhead.
Note:
To adjust the shower temperature.
The water temperature is altered by increasing
or decreasing the fl ow rate of water through the
shower unit via the temperature control.
To increase the shower temperature.
Turn the temperature control knob clockwise,
this will decrease the fl ow of water and increase
the shower temperature.
To decrease the shower temperature. Turn the
temperature control knob anti-clockwise, this
will increase the fl ow of water and decrease the
shower temperature.
6. To turn off the shower unit, turn the power
selector knob to the OFF position.
7. A small amount of water will be retained in
the showerhead after the shower has been
turned off. This may drain over a few minutes.
8. Switch of pull-cord or wall mounted switch.
WARNING
IF RE-STARTING THE SHOWER IMMEDIATELY AFTER STOPPING, BE AWARE THAT A SLUG
OF HOT WATER WILL BE EXPELLED FOR THE FIRST FEW SECONDS.
!

!
!

!
TTeee TTTTTT m
mpera
rr tuurree
rrrr
COOLER COOLER
WARMER WARMER
eco eco
eco eco
eco eco
eco eco
ON/OFF
COLD
HOT
ECO
12. SHOWERHEAD CLEANING INSTRUCTIONS
The showerhead should be cleaned periodically to remove limescale or debris which will
reduce the performance of the shower. The frequency of cleaning will vary according to local
water quality.
PERIODICAL MAINTENANCE
1. To break away scale
deposits on a daily basis
simply rub your thumb
over the surface whilst the
shower is running.
2. If scale deposits
are stubborn,soak
the showerhead in a
proprietary limescale
remover and rinse
thoroughly before use.
3. Remove the fi lter from
the bottom of the shower
clean out any debris by
washing in clean water.
Refi t fi lter.
ATTENTION!
DO NOT OPERATE THE SHOWER UNIT IF THE SHOWERHEAD
OR HOSE BECOMES DAMAGED.
THE SHOWER IS DESIGNED AND APPROVED TO EN-60335 WITH THE SHOWERHEAD
PROVIDED. UNDER NO CIRCUMSTANCES MUST ANY SHOWERHEAD THAT IS NOT
APPROVED BY THE MANUFACTURER BE USED WITH THIS PRODUCT.