15
TS2330 - NLFREN - v1.0 - 20012017
EN
4. Fully raise the handle to insert the next block. Normally there should be no need to make further height adjustments to split
similar material. To split blocks of another size, follow steps 1 and 2.
1
3
2
Undercut
Because it is splitter, not saw, the result will be smooth straight edge on the top and bottom of the unit being split and a “split-
face” in between. The spring loaded tables offer the ability to create an undercut when splitting. Undercutting will allow the top
of the unit to be placed close to the adjoining one.
Place the unit to be split in the splitter and push down on the unit on the spring-loaded table. Then lower the handle (this may
require adjustment of the upper blade before the first split again) making sure the line on the top of the unit is lined up with the
upper blade. With the handle lowered and both blades touching the unit, there is no more need to push down on the unit. The
contact of both blades will keep the unit at an angle. Then following the same splitting instructions as before.
copyrighted
document
- all
rights
reserved
by
FBC
