
M1.2.HNFJ2T.NLFREN 13022017
3
NL
Page 2 of 2
Changshu Tongrun Auto Accessory Co., Ltd.
Use the handle (C) to pull the direction latch (D) up
until it clicks into place;
Hold the beam (F) steady and pull the operating
lever (E) downward, (or forward if used horizontally);
Continue to pump the lever;
When the load is lifted to the required height, set
the lever in the upright position and engaged the
clip (G) onto the beam;
Place a ½” high stress bolt (not supplied) through
the hole immediately below the lifting mechanism to
act as a safety pin, or use a jack stand;
To lower a load, push the direction latch down (still
use the handle C), pump the lever (the load must
be a min. 75 kg).
4. C
LEANING AND MAINTENANCE
The jack does not require special maintenance, but it must be kept well lubricated;
Inspect the jack before use for damage and cracks, and do not use it if it is not in proper
condition;
Front and back of the rail must be kept rust free, do not use it when rusting happened.
Changshu Tongrun Auto Accessory Co., Ltd.
Address: New Longteng Industrial Park, Changshu Economic Development Zone, Jiangsu Province,
P.R.China.
3 Gebruik
• Gebruik de handgreep (C) om de grendel (D) omhoog te
trekken, totdat deze vastklikt.
• Houd de rail (F) stevig vast en trek de bedienhendel (E) omlaag
(of naar voren indien u horizontaal werkt).
• Ga verder met de hendel te pompen.
• Wanneer de lading op de gewenste hoogte opgeheven is, zet
de hendel in verticale positie en laat de klem (G) in de rail
ingrijpen.
• Steek een 1/2’’ hoge sterkte bout (niet meegeleverd) door
het gat direct onder het hefmechanisme, als veiligheidspin, of
gebruik garagestands.
• Om de lading omlaag te brengen, duw op de grendel (D)
omlaag, steeds door handgreep (C) te gebruiken, en pomp met
de hendel. De lading moet tenminste 75 kg bedragen.
4 Reiniging en onderhoud
• De krik vereist geen speciaal onderhoud, maar moet steeds ingesmeerd zijn.
• Controleer de krik voor ieder gebruik, op scheuren of andere defecten. Gebruik de krik niet in geval van
beschadiging.
• De voor- en achterkant van de rail moeten roestvrij blijven. Gebruik de krik niet indien roestvlekken
verschijnen.
copyrighted
document
- all
rights
reserved
by
FBC