10
M1.2.LD2.NLFREN - 05122017
EN
1 Safety instructions
• This equipment is designed for paint curing application. Keep a safe distance between emitter and panel. Improper
servicing can cause paint surface damage.
•
Installation and service must be performed by a qualified installer or service agent.
• The system has been designed for easy installation, low operating costs and minimal maintenance. The warranty does not
cover lamp tube defects resulting from misuse or improper operation.
• Disconnect power source when the equipment is not in use for a long period.
• The lamp tube should not be perpendicular to the ground when the equipment is operating. Otherwise, it will shorten the
life of the lamp tube.
• Turn off the equipment after using. Place the equipment in a safe place to avoid damage to the lamp tube.
2 Technical parameters
Model
LD2
Power supply
230 V
Input power
2 x 1000 W
Curing area
800 x 800 mm
Temperature
30 - 100 °C
Timer
0 - 60 min.
Light intensity
10 - 100 %
Dimensions
580 x 500 x 1600 mm
Net weight
19 kg
3 Installation
The shortwave infrared curing lamp is divided into 3 parts (a base, a frame and a cassette)
1) Installation of the base:
a. Open the packing of the base.
b. Install the four wheels on the base and tighten up the screws.
Usually, the wheels with brakes are mounted on the rear of the base.
2) Installation of the frame:
a. Open the packing of the frame.
b. Put the column onto the top of the base, line up the screw holes and tighten up
with screws.
3) Installation of the cassette:
a. Open the packaging of cassette with care.
b. Connect cassette with holder and tighten up by screws.
c. Connect control wires and adjust the angle of the lamps.
Page 3
1. Main switch
2. Control box
3. Cassette
4. Cassette
5. Holder
6. Column
7. Base
8. Caster
3. Installation
1
2
3
4
5
6
7
8
copyrighted
document
- all
rights
reserved
by
FBC
