10
EN
M1.1.WEL33.NLFREN - 25042019
6 Cleaning and maintenance
1. Before cleaning the appliance, disconnect it from the socket and let it cool down. The enclosure is easily to get dirty, wipe
it often with soft sponge. For every dirty parts, wipe with a sponge dipped in <50°C water and mild detergent, then dry
the heater enclosure with clean cloth. Be careful not to let the water enter the appliance inner. Don’t splash water onto the
heater, never use solvent like gasoline etc. to clean the heater, in order to protect the enclosure.
2. Clean the cord and plug, dry and pack it in a plastic bag.
3.
When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in a packing box and
store it in a dry, ventilated place.
7 Trouble shooting
You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if
you can solve the problem before calling the service centre.
Problem
Possible causes
Solutions
The heater does not operate, even
when it is plugged in and the switch,
thermostat are switched on
The plug is loose, bad connection
Pull out the plug, check the connection of
the plug and socket. Then connect again
No power in socket outlet
Insert the plug in a proper socket
The heating element is glowing
The input voltage is too high or too
low
Use power supply according to the rating
on the label
The air inlet grill is blocked
Keep the heater far way from articles like
curtain, plastic bag, paper and other
things which can cover the inlet or can be
easily cover on the air inlet
The appliance does not heat up, or
only ventilator works
The switch is not put at heating setting Turn the switch to heat setting
The thermostat operates
Turn the thermostat and listen if there
is open/close voice. If there is no click
and the thermostat is not damaged, the
heater will automatic switch on when the
appliance cooled down
The self-resetting cut-out operated
Turn the heater off and inspect the
blockage of inlet or outlet. Disconnect
the plug and wait at least 10 minutes
for the protection system to reset before
attempting to restart the heater.
Abnormal noise
The appliance is not stands upright
Put the heater on a level surface
8 Disposal
Environmental protection
Waste electrical production should not be disposed of with household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice.
copyrighted
document
- all
rights
reserved
by
FBC
