MW MACH 790004461, Руководство пользователя, Страница: 15 / 21

15
EN
MACH
M1.1.ETA12915-ETA16915.NLFREN 06112017
• Do not leave the machine unattended while it is working, unless you are in a controlled access area.
• Do not approach the head too much, nor climb on the machine.
• Do not exceed the speeds and power indicated in the speeds table of the tool manufacturer, since this can cause its
breakage and a failure in the machine.
2 Technical specifications
Model ETA12915 ETA16915
Power 1 kW 1.2 kW
Voltage 1 x 230 V 1 x 230 V
For taps M2 - M12 M2 - M16
Speed 0 - 600 rpm 0 - 250 rpm
Effective range 360° 915 Rmax mm 915 Rmax mm
Torque 30 Nm 50 Nm
Net weight 20 kg 22 kg
Dimensions 670 x 585 x 205 mm 670 x 585 x 205 mm
3 Machine overview
1 Servo motor
2 FOR/EBR key
3 Gearbox
4 Spindle
5 Chuck
6 Tapping arm
7 Movable joint
8 Control box
9 Fix base
A B C D E
A Chuck box with 6 chucks and adjusting wrench 1 set
B
Install screw for machine base 3 pcs
C
Wire casing and screw 4 pcs
D Install screw for motor 2 pcs
E Power line and plug 1 pcs
F Operation Instruction 1 set
Before proceeding to install machine
1. Inspect the delivery for completeness and obvious signs of damage. Report
an incomplete or damaged delivery to your supplier/retailer immediately.
2. The machine location area must have an even surface and be perfectly
lighted.
3. Be sure that the place is clean and particle free, which could alter the
machine stability.
Installing machine steps
1. Drilling fix hole on the working table. The size and distance of the hole as
following picture. Be sure it is strictly as same as drawing required.
2. Install and fix arms with foundation on the working table by 3 pcs screw
( Delivery contents
B
).
3. Take motor and control box out, install and fix motor head on the arm by 2
pcs screw ( Delivery contents
D
).
1 Servo Motor
2 FOR/EBR key
3 Gearbox
4 Spindle
5 Chuck
6 Tapping Arm
7 Movable Joint
8 Control Box
9 Fix Base
Machine Overview
Delivery Contents
Installing Machine
6
5
As you see on opposite picture, there are two screws on the
base of the machine, which can be tightened and loosen
with a Hex wrench. The whole base can be rise for
40-60 cm to enlarge the vertical tapping scope.
copyrighted
document
- all
rights
reserved
by
FBC