MVP Patriot Megaject Innovator II, Руководство по эксплуатации

Страница: 53 / 78

Patriot Megaject Innovator II Operations Manual
Rev. 04/2014 Page | 53

Catalyst Overpressure circuit is engaged (check indicator on panel)

Check for blockage in catalyst delivery lines.

Check FC #04 for proper adjustment.

Check for air leaks on Catalyst Overpressure valve and connection 1B-7(21).

Internal Catalyst Overpressure circuit check

Check (21) for leaks

Check V03 output (49) for signal. Should not be on.
Predetermined counter not counting or skipping counts

Will not count in recirculation mode

FC#03 not adjusted properly

Adjust FC#03 for proper flow
.

Faulty signals from powerhead shift block

Repair or replace powerhead shift block.

Faulty RGA V03 valve or OR09 shuttle

Check (60) for signal. Should go on/off with pulses from powerhead.

Faulty counter

Check (60) for signal. Should go on/off with pulses from powerhead.
Cat OP circuit does not stop pump

FC#04 not adjusted properly.

Adjust flow control

Remove (21) from Catalyst Overpressure valve, start pump, slowly turn in FC#04 until pump stops.
MPG will not stop pump on overpressure

Reduce MPG pressure from panel.

FC#04 not adjusted properly
.

Adjust flow control

Remove (26) from MPG valve, start pump, slowly turn in FC#06 until pump stops.
Gel Alarm time incorrect

FC#03 not adjusted properly.

Adjust flow control until gel alarm is set correctly.
Gel Alarm not working

FC#03 not adjusted properly.

Adjust flow control until gel alarm is set correctly.

Check RGA V02 (51) for signal. Should be off/pulsing when pumping. On when not pumping.

Check RGA V02 output (52) for signal. Should be off/pulsing when pumping. On when not pumping.
Flush dwell time incorrect

FC#05 not adjusted properly
.

Adjust flow control until flush dwell is set correctly.
Flush not working

FC#05 not adjusted properly.

Adjust flow control until flush dwell is set correctly.