MVP HVDG-2000, Руководство по эксплуатации

Страница: 25 / 61

High Volume 1:1 Pro Gun Operations Manual
Page | 25
36. Thread the auto/manual flush body assembly into the flush valve body.
37. Screw the flush valve assembly into the front side port on the resin side of the gun block.
Assemble Gun Head
38. Install the two check face seals into the front of the gun block.
39. Install the locator pin into either the gun block or gun head, as applicable.
40. Mount the gun head onto the gun block using the four cap screws.
41. If you have the ratio gun head setup (HVDG-2204), skip to Rebuilding Actuator.
42. Install the side plugs and seals into both sides of the gun head.
43. With the gun head pointing upward, place the ball into the front part of the gun head.
44. Place the spring on top of the ball.
45. Screw the front plug and seal into the front port of the gun head, making sure the spring
centers on the pin on the front plug.
Rebuilding Actuator
1. Remove the end cap from both ends of the cylinder body.
2. Push the actuator piston out of the back of the cylinder body.
3. Replace the O-ring on the actuator piston
4. Check the actuator bushing and cylinder body for wear or damage.
5. Apply a light film of Pro Gun oil to both the incise of the cylinder and actuator piston.
6. Install the actuator piston into the cylinder body with the actuator bushing first and off
center toward the top.
7. Install the end cap onto both ends of the cylinder body.
8. Align the actuator stem on the gun block with the actuator bushing in the cylinder body.
9. Attach the gun block to the cylinder using the four screws and seats.
Parts Drawings
The following drawings are included in this manual for reference:
Parts Drawings
Part Number Description
HVDG-2000 HV DUO GUN ASSEMBLY
HVDG- 2000-DR HV DUO GUN ASSEMBLY – RATIO GUN HEAD
HVDG-2000-TM HV DUO GUN ASSMELBY – TUBE MIXER
HVDG-2100 HIGH VOLUME DUO GUN BLOCK ASSEMBLY
HVDG-2100-DR HV DUO GUN BLOCK ASSEMBLY – RATIO
HVDG-2100-TM HV DUO GUN BLOCK ASSEMBLY – TUBE MIXER