MVP HVDG-2000, Руководство по эксплуатации

Страница: 22 / 61

High Volume 1:1 Pro Gun Operations Manual
Page | 22
4. Place the center spacer into the gun block, making sure that it is
aligned as accurately as possible with the slot facing up.
Note Be careful not to damage the secondary seals already
installed.
Reassemble Resin & Hardener Components
5. Place the resin seal components onto the seal installation tool in the following order:

Packing ring

Seal

Relief spacer
Note The hole in the seal should be aligned with the port hole in the gun block.
6. Insert the seal installation tool with the components on it into the appropriate side of the gun
block.
7. Press firmly or tap with a rubber mallet.
8. Pull the packing tool out of the gun block.
The seal components should be seated in the interior of the gun block against the center
spacer.
9. Check that the hole in the seal is properly aligned with the holes in the gun block by looking
through the ports in the gun block.
10. Gently screw a packing nut into the gun block; do not overtighten.
11. Repeat steps 5 through 10 with the hardener seal components on the catalyst side of the gun.
Note At this point the packing nuts should only be hand tight.
Install Valve Rod
12. Insert the valve rod into the gun block through the resin side, using the seal installation tool
to center the valve rod.