MVP HVDG-2000, Руководство по эксплуатации

Страница: 16 / 61

High Volume 1:1 Pro Gun Operations Manual
Page | 16

Adjustable wrench

Needle-nose pliers

Flathead screwdriver

Lubriplate™ lubricant

Scribe set

Pro Gun oil

Seal installation tool

HV Pro Gun packing bit
You need appropriate cleaning materials such as solvent, clean shop towels or rags, a small
brush, and empty containers into which you may flush the gun. You will also need new O-rings
and seals to replace the current ones. Refer to the parts drawing for your model to ensure you
obtain correct part numbers for the O-rings and seals needed.
Note If you are using O-ring part number O-K-008 in the flush assembly, you do not
need to replace the O-ring unless it is showing obvious signs of wear. This O-
ring is specially designed to handle most solvents.
Disassembling Gun
Release Pressure
WARNING
To prevent accidental injection injury disconnect all air and electrical power
to the unit before beginning repair or maintenance of this equipment.
1. Turn off air supply to pump and set regulator to zero (“0”).
2. Hold the gun over an appropriate container and activate the gun to release fluid pressure
from the lines.
3. If your system has a recirculation assembly, release the pressure from those lines as well.
4. Flush the gun into an appropriate container.
5. Turn OFF the main air supply to the unit.
6. Turn OFF air supply to the solvent tank.
7. Release any pressure in the flush tank by gently pulling upward on the ring attached to the
pressure relief valve.
Remove Hoses
CAUTION
If you followed previous steps you should have removed all pressure
from the lines, however there may still be trapped fluids in the lines.