AccessZone ® - GC500 Series – GC501-GC504 User Manual
19.2 Mobile Phone used for System Commands - System Configuration Mode:
All mobile phones can in system configuration mode be used to enter system commands like
adding and deleting users. Refer to section 7.2 How to enter Configuration Mode for more details
about the systems commands:
The system will prompt for the 8 digit Master PIN code if a valid system command is found.
Steps:
1) Set system into configuration mode by holding the REX button pressed while powering up the
device. Refer to section 7.2 How to enter Configuration Mode for more details
2) Enable Bluetooth on the mobile phone and set it to hidden
3) Temporarily change the Bluetooth friendly name to the desired command:
Examples:
•
Change Master PIN
(Refer to section 7.2 How to enter Configuration Mode):
Change Master PIN to 12345678 enter: "
12345678
"
•
Add User
(Refer to section 8.2 Add new User Command):
Add unique user 0022b4b62918 with PIN code 1234 enter on position 1:
"
01,0022b4b62918,1234
"
or
Add unique user 0022b4b62918 without PIN code enter on position 5:
"
05,0022b4b62918,0000
"
•
Delete User
(Refer to section 8.3 Delete User Command):
Delete user stored on position 1 enter: "
01
" or on position 5 enter "
05
"
•
Door Remain Open Time
(Refer to section 8.4 Change System Configuration Command 1)
Activate the door mechanism for 5 s with 1 s warning buzzer on open/close, door type is
level, enable alarm bypass function for the first 5 user enter: "
05,01,1,0,05,10
"
•
Change Detection Range
(Refer to section 8.5 Change System Configuration Command 2 –
Advanced settings):
Select power range 2 (<10 m), and approximately 5 m with input 1 and 2 active at low level
(GND) and output 1 and 2 with high level enter: "
2,6,50,0,0,1,1
"
4) Set the mobile phone to visible
5) Place mobile phone within the detection range of the system
6) Wait for 3 short beeps which indicate that a valid command has been found and Master PIN
code is required
7) Enter 8 digit Master PIN code on mobile phone when prompt
8) Wait for beep for successful execution
9) Set the mobile phone to invisible/hidden
10) Erase the command in the mobile phone
For more commands – repeat step 2) – 9)
If no more commands are required - Set friendly name back to desired name.
All information is subject to change without notice. All other products and brand names are registered trademarks of their respective companies
2010-07-06 US 1.17
Copyright © 2005-2010 All rights reserved MVC-Data ApS Skalhuse 5 9240 Nibe Denmark Web
www.mvc-data.com
Phone +45 25 12 84 02
33/34
