AccessZone ® - GC500 Series – GC501-GC504 User Manual
7.2
How to enter Configuration Mode
The system must be set into configuration mode before it will accept the system commands.
However, it is possible for two privileged users (administrators) to use the Add new User and
Delete User commands in normal mode (Refer to section 7.4 How to Add or Delete Users – Normal
Operation).
Follow these steps to enter configuration mode:
Steps:
1) Power off the module
2) Press and held down (GND) the REX (Request Exit) push button (IN2)
3) Power on the module again
4) The REX push button can be released after the short beep
The system is now in configuration mode for 10 minutes and will flash with the Blue LED. Refer to
section 7.3 How to enter System Commands – Configuration Mode for how to enter system
commands.
The system coverage range will be limited to approximately 20 cm in the configuration period to
prevent that unauthorized people can tamper with the system.
The configuration period is restarted every time a valid command has been executed.
Configuration mode is automatically terminated after 10 minutes without any valid commands by
sending 2 short beeps or by power cycling the device to startup in normal operation.
Caution!
The system will not scan for (detect) users in configuration mode. I.e. no access is possible
All information is subject to change without notice. All other products and brand names are registered trademarks of their respective companies
2010-07-06 US 1.17
Copyright © 2005-2010 All rights reserved MVC-Data ApS Skalhuse 5 9240 Nibe Denmark Web
www.mvc-data.com
Phone +45 25 12 84 02
11/34
