MV Heating MV Airo 4, Инструкция по эксплуатации, Страница: 26 / 48

+44 (0)23 8052 2345
26
MV Heating UK Ltd
Electrics:
Components
Make sure that all electrical components are arranged in the vehicle so that
they function correctly under normal heater operations. Firstly, ensure that
no wires are damaged in any way and avoid feeding them through areas that
may cause damage to the loom or cause kinking, jamming or exposure to
heat. If necessary, fit rubber grommets and plugs around the loom in areas
that are not waterproof or may get damaged by road debris. Lastly make sure
all connections are free of corrosion and all firmly connected.
Control Switch & Timer
To install the control switch, simply remove the rotary knob (it is quite stiff)
and secure in a suitable location with the screw provided, then replace the
knob back in the correct location. Alternatively, to fit the mini timer, simply fit
the appropriate screw inside the hole located at the center of the timer. Both
plug into the corresponding black and clear plugs on the loom.
Note: Only one can be installed at a time.
External Temperature Sensor Probe
The external temperature sensor probe plugs into the corresponding blue and
brown wired socket on the diagram and should ideally by mounting at
shoulder height when sat down to ensure correct reading of the air
temperature. It should not be mounted in such a way as to obstruct air flow;
like up high, in the corner of the vehicle cabin or above heat sources.