_________________________________________________ MuxMeet Share Base-1 Operation Manual
© MuxLab Inc. 2022 Page 16 94-000977-A/SE-000977-A
4
I
NSTALLATION
The installation chapter gives an overview of the different ways to install and connect MuxMeet Share Base-1 unit.
Overview:
•
Installation methods for the Base unit
•
Table mounting
•
Wall mounting
•
Recommendations about antenna placement and orientation
•
MuxMeet Share Base-1 Power Connection
•
MuxMeet Share Base-1 Video Connection
•
MuxMeet Share Base-1 Audio connection
•
MuxMeet Share Base-1 LAN connection
•
About USB device connection
•
Wiring Diagram
4.1
I
NSTALLATION METHODS FOR THE
M
UX
M
EET
S
HARE
B
ASE
-1
UNIT
The Base unit can be installed in different ways in a meeting room.
•
Table mount
•
Wall mount
The articulated antennas are removable. They can rotate for better wireless connection.
Attention:
For optimal performance, install the Base unit close to the display and avoid obstacles between the Base unit and
the Transmitters.
Necessary tools
•
A drill (type of drill depends on the type of wall)
•
The mounting screws (mounting screws not included in the package)
Necessary parts
•
2 mounting screws (the screw-head diameter shall be within 6-8mm)
How to install
1.
Drill two holes in the wall. Horizontal distance: 177 mm ± 0.15
2.
At the bottom of Base Unit, turn in 2 flat screws into 2 holes of its smallest diameter to be fasten enough.
Note: Mounting screws are not included. The type of screws depends on the type of wall (stone, wood, plasterboard, ...) you
are mounting the Base Unit to. Make sure the head of the screw is not larger than the hole in the bottom of Base unit.
