HDMI 4K/ST2110 Over IP Uncompressed Gateway
Operation Manual
© MuxLab Inc. 2020
29
3.
Frequently Asked Questions
The following FAQ section provides answers to the most frequent questions you
may have regarding the configuration of the 500774.
What is the default IP address of the 500774?
The 500774-TX default IP addresses are set to DHCP. If no DHCP is available
on your network the TX will default to the following static IP Addresses:
•
1G Management/Control port (LAN): 192.168.168.64
Subnet Mask: 255.255.255.0
•
Media/Data 1 port (Fiber 1): 192.168.168.65
Subnet Mask: 255.255.255.0
•
Media/Data 2 port (Fiber 2): 192.168.168.66
Subnet Mask: 255.255.255.0
The 500774-RX default IP addresses are set to DHCP. If no DHCP is available
on your network the RX will default to a the following static IP Addresses:
•
1G Management/Control port (LAN): 192.168.168.67
Subnet Mask: 255.255.255.0
•
Media/Data 1 port (Fiber 1): 192.168.168.68
Subnet Mask: 255.255.255.0
•
Media/Data 2 port (Fiber 2): 192.168.168.69
Subnet Mask: 255.255.255.0
Note: In the above cases if the user changes the static IP addresses from their
default values, then the user defined static IP Addresses will be used when do
DHCP server is present. However, if the unit is Factory Reset then the default
static IP Addresses above will apply.
How to find the 500774 IP address?
You can check
the unit’s IP address by using either Wireshark, or going to your
network switch Web interface on the 1G Ethernet port.
