MUTOH ValueCut VC-1300, Руководство по обслуживанию

Страница: 39 / 63

MAINTENANCE MANUAL
VCE-MM-02
39
Adjusting the Tool Carriage Transmission Belt
When you replace the tool carriage or belt itself, the belt tension needs to be adjusted. This is done as
follows:
Note: Fasten the retaining screws on the top of the carriage belt roller housing once the adjustment
is made.
1. Move the tool carriage to the far left
end of the guide beam after the tool
carriage or belt being replaced.
5. To tighten the tension, turn the belt tension
screw clockwise. To loosen the tension turn
the belt tension screw anticlockwise, until
the desired adjustment tension is reached.
The desirable tension is as follows.
VC-600 650g
～
850g
VC-1300 220g
～
320g
VC-1800 180g
～
200g
2. Loosen the 2 retaining screws on top of
the carriage belt roller housing.
3. Use a tension gauge to measure
the belt's tension by placing
the gauge's push arm to the
center of the belt, as seen in
the figure above.
4. To change belt tension adjust the belt
tension screw on the side of the
carriage belt roller housing.