5
Installation
Introduction
This unit will deliver the ultimate performance
possible from any digital source. It is designed to
upgrade CD players, TVs, set-top-boxes, DAB tuners,
and any other source providing a variety of digital
outputs.
Cleaning
Before cleaning the unit, switch off power at the
mains switch and remove the mains plug from the
wall socket. Clean the cabinet and remote control
unit using a moist cloth. Using solvents, white spirit
or thinners is not advised, as they could damage the
surf
ace finish.
Installation
Position the M6SRDAC on a stable, horizontal
surface where there is no risk of it being knocked,
or subjected to vibration such as from loudspeakers.
Power Connections
The M6SRDAC is supplied with a standard IEC mains
cable which plugs into the IEC socket at the back of
the unit.
Audio Output Connections
RCA audio outputs:
Use good quality RCA phono
audio cables (fully connected signal and ground), for
optimum signal transfer.
XLR audio outputs
: Use good quality XLR audio
cables (fully connected hot and cold signals and
ground), for absolute optimum signal transfer.
Digital input connections
COAXIAL inputs:
Connect RCA digital source to
digital input RCA socket. Use a good quality fully
connected (signal and ground) coaxial digital cable,
for optimum signal transfer.
OPTICAL input:
Connect optical digital source to
optical input socket. Use a good quality “Toslink”
cable, for optimum signal transfer.
USB input:
Connect computer or similar USB “host”
source to USB input socket. Use a good quality
USB 2.0 type cable (not supplied),
for optimum signal transfer. Try to keep USB cable
length to a minimum for best reliability. The USB
standard maximum for a single cable is 5M, after
which repeaters (normally mains-powered USB hubs)
are required. We do however; recommend avoiding
such a setup if at all possible.
Interconnects
If necessary, please refer to the dealer who can
advise on quality cables for any particular setup
Note: In normal operation, the unit dissipates
a small quantity of power at all times, and it is
important that it is adequately ventilated. The
M6SRDAC must be protected from humidity – if
the unit is moved from a cold place to a warm
room, leave the unit for an hour or so to allow
sufficient time
for the moisture to evaporate.
Note: Musical Fidelity currently do not make any
interconnecting cables other than those supplied
with the unit. Musical Fidelity does not endorse
any other manufacturer’s cables.
Содержание M6SRDAC
Страница 1: ...Instruction Manual ...
