Murphy PowerCore MGC1000, Руководство по эксплуатации

Страница: 12 / 48

Software Release: [TBD]
Section 40 12 00-02-1167
2018-09-18
The Digital Inputs of this menu can be configured from the face of the controller to accept three types
of inputs as the Active state of the input.
• High, B(+)
• Low, B(-)
• Open
The Analog Inputs of this menu can be configured from the face of the controller to accept one of four
types of senders:
• Resistive
• 4-20mA
• 0-5VDC
• Analog.Digital (B- for additional Digital Inputs)
The Outputs are configurable for the operator to choose which output function to use with the desired
output type as shown below.
• Relay [10A, Form C]
• Digital Out [1A, B(+)]
• Digital Out [1A, B(-)]
NOTE: Although the functionality exists to set all analog and digital inputs to the same
function, Enovation Controls strongly advises against this.
Start / Stop Timers
The Start/Stop Timers menu provides the operator the ability to add a countdown timer, scheduled
start/stop times, and an engine exercise timer. All Start/Stop timers only work when the controller is set to
auto mode. The countdown timer allows for the operator to set a desired countdown time and walk away
from the engine for a controlled shutdown when the timer expires. There are three Start/Stop Timers the
operator can choose from within this menu that allows for the specific day and hour the controller will start
and stop utilizing the internal clock. Review Start/Stop Timers under Menu Glossary section of this manual
for full list and definition of each setting.
NOTE: Start / Stop timers work in conjunction with other Start / Stop types. The Start /
Stop times are independent of the other Auto Start methods. If the engine is already
running from another Start / Stop type when a Start / Stop timer occurs, the Start / Stop
timer is ignored. Once the engine is started by the Start / Stop timer the Auto Stop
method is ignored and will be stopped by the set Stop time.
Figure 6: Main Menu page 3