Murphy HelmView 450, Руководство по установке

Страница: 5 / 24

Hardware Installation
The following instructions will guide you through installing the HelmView™ HV450 display.
Inspecting Package Contents
Before attempting to install the product, it is recommended that you ensure all parts are
accounted for and inspect each item for damage (which sometimes occurs during shipping).
The items included in the box are:
Installation kit – P/N 78-00-0782 includes:
•
4 ea. machine screws and flat washers
•
4 Nylock nuts
•
1 small bag
Dash-Mounted Installation
Tools Needed
•
Drill with 5/32” size bit
•
Jigsaw or tool that can make a clean cut through the dash material
•
Wrench or socket
Preparing the Dash
Determine the location of the HV450 in the dash. Use the Installation Template (included at the
end of the manual) as a guideline to cut a hole in the dash to the specified dimensions. Drill
holes where indicated on the template for the mounting screws.
NOTE : When using the paper template from the manual, please be aware that if
you downloaded this document from the FW Murphy website, the pdf file may not
automatically print to scale. When submitting the file for print, you will need to
select None for Page Scaling. Check the accuracy of the printed template by
verifying the measurements labeled on the template are correct.
NOTE : If this manual was supplied with your product, the template will be correct
Section 78 00-02-0727
2015-04-16 - 1 -