Murex Tradesarc 150, Инструкция по эксплуатации

Страница: 6 / 24

-- 6 --
bh33d1me
5 INSTALLATION
The installation must be executed by a professional.
Note!
Mains supply requirements
High power equipment may, due to the primary current drawn from the mains supply, influence the
power quality of the grid. Therefore connection restrictions or requirements regarding the
maximum permissible mains impedance or the required minimum supply capacity at the interface
point to the public grid may apply for some types of equipment (see technical data). In this case it
is the responsibility of the installer or user of the equipment to ensure, by consultation with the
distrubution network operator if necessary, that the equipment may be connected.
5.1 Location
Place the power source so that its cooling air inlets and outlets are not obstructed.
5.2 Mains power supply
Check that the welding power source is connected to the correct voltage and that the
correct fuse size is used.
The standards for the country in question must be complied with as regards the
mains cable area.
A protective earth connection must be made in
accordance with regulations
Rating plate with supply connection data
5.2.1 Recommended fuse sizes and minimum cable area
Tradesarc 150
Mains voltage
230 V
¦
10 %, 1--phase
Mains frequency 50--60 Hz
Mains cable, area 3G2.5 mm
2
Phase current I
1eff
11 A
Welding cable, area 16 mm
2
Fuse
anti--surge
type C MCB
16 A
13 A
*) NOTE! The installed plug is approved for max. 16A.
NOTE! The cable area and fuse rating above comply with Swedish regulations. Use the welding
power source in accordance with the relevant national regulations.
GB