1. Install –MF3 Chiller and Drinking Fountain Wall
Mounting Frame following the instructions
included with the frame.
2. Verify frame chiller shelf is secure and install
the chiller following the instructions included
with the chiller
INSTALLATION:
3. Hang upper trim panel on mounting frame.
Note: The included 1” brackets do not get used
with this installation and the plastic spacers are
typically not required and can be discarded.
4. Install the four threaded studs into the Wall
Mounting Frame.
5. Remove the drinking fountain top 1 by taking out the drain screw 2 and lifting at the front while
pulling forward. Disconnect bubbler tube 3 . Set top 1 aside in a safe place where it will not be
damaged. Place the screw 2 in a secure location where it will not be lost.
6. Slide fixture over studs and secure with nuts and washers 4 .
A151.8-VR
Page 5 of 11
Date:
11/10/2020
7021-024-001
MURDOCK MFG. •
15125 Proctor Avenue • City of Industry, CA 91746 USA
Phone 800-453-7465 or 626-333-2543 • Fax 626-855-4860 • www.murdockmfg.com
Member of
1
2
3
9
5
4
8
7
6
BUBBLER
CONNECTION
DETAIL
CONTEMPORARY WATER COOLERS
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
DRINKING FOUNTAINS
