SN8000 EVK User Guide
Page 22 of 30
Download complete
Note:
If the EVB is not recognized by the programming tools, it may be necessary to disconnect
and then reconnect the board to the computer before trying again. The following message
indicates there was an error with the download process:
"**** OpenOCD failed - ensure you have installed the driver from the drivers
directory, and that the debugger is not running **** In Linux this may be due
to USB access permissions. In a virtual machine it may be due to USB
passthrough settings ****"
Resetting target
make: *** [run] Error 1
3.4 Run the application
This section assumes you have successfully completed previous section, and the scan application is running
on the SN8000 EVB.
After power-on-reset, the scan application prints status messages to the USB UART of the SN8000 EVB.
To verify printing, launch a terminal application such as Microsoft
®
Hyper Terminal. (For Windows XP,
it’s located at
START
>
All Programs
>
Accessories
>
Communications
>
Hyper Terminal
)
Use following settings on COM port connected (in this example it’s COM 18):
Содержание SN8000 EVK
Страница 17: ...SN8000 EVK User Guide Page 16 of 30 Figure 6 Uninstalling USB drivers...
Страница 27: ...SN8000 EVK User Guide Page 26 of 30 b Select the correct STM target i e STM32F2_1024K for STM32F205RG...
Страница 29: ...SN8000 EVK User Guide Page 28 of 30...
Страница 31: ...SN8000 EVK User Guide Page 30 of 30 END...
