Murata MEMS Evaluation
Unit User Manual
Murata Electronics Oy
Subject to changes
16/34
www.murata.com
Doc.Nr. 82175700
Rev.D
5.4.4 Chart data points
This control specifies how many samples will be visible on the chart. Note that this control will have
an effect on the performance of the application when a large amount of data is visible on the
charts.
Figure 20. Dialog to set number of data points for the chart
5.4.5 Zooming the chart
The chart cannot be updated while zooming, so the user must first freeze the chart, then the left
mouse button can be used to zoom the chart. After zooming, the GUI shows data markers
according to the mouse position on the chart and their numeric values in a tool tip message. The
figures below show the chart before and after zooming. Use the
Reset zoom
button to zoom out.
Use the
Update chart
button to zoom out and start updating data points for the chart.
Note: Do not zoom outside the chart panel or the zoom will automatically reset!
Figure 21. Chart before zooming
Figure 22. Chart after zooming
