19
© Munters Corporation, August 2018
QM1190r7
10-0V
Output
In Control
Electrical Wiring
Chapter 3
To operate the Munters Drive Off/Variable with a 10-0V Signal, slide the ‘RUN’ switch, located on the circuit
board in the Munters Drive Box, to the ‘OFF’ position. Now wire an ‘ON’ command from the ‘COMMON’
terminal to the input relay in the control and from the output of the control relay to the ‘RUN’ terminal in
the Munters Drive Box. Also, connect wires from the ‘0-10V IN’ and ‘0-10V COMMON’ terminals in the
Munters Drive Box to the 10-0V output in the control.
See Figure 13G.
Figure 13G
On/Off with Variable Speed Operation
Control
Relay
Munters Drive Box
‘RUN’ Switch
Circuit Board in Munters Drive Box
WARNING:
Fan is designed to be operated with shutter in place. Do not apply power to fan without
shutter being installed.
Munters Drive Box
Junction Box
(By Others)
