9
© Munters Corporation, January 2020
QM1086r8
Note:
If installing your existing guard in the new
Polycone, then proceed to Step 9. If installing
the new snap-in guard then proceed to Step 7.
Installation Instructions
Chapter 2
Figure 6
Remaining Holes
Cone
Step 6
Work down the sides of the cone, sliding the cone tabs onto the fan until the bottom tab is in place. Keep
pressure on the cone to make sure tabs stay on the fan. Install (6) Truss Head Bolts [B], Washers [C] and
Flange Nuts [D] in the remaining holes in the fan outlet and slots in the cone to finish securing cone to fan.
See Figure 5B and Figure 6.
Tighten all nuts at this time, making sure not to over tighten.
Figure 7A
Step 7
The snap-in guard has a slight conical shape to it so, when installed the center of the guard should protrude
out slightly.
See Figure 7A.
Cone
Guard
