7. WIRING
Specified power cables should be used. Do not apply any
pressure on the terminals used to connect.
Improper connection may cause fire.
Grounding must be properly done.
The grounding wire should be away from gas pipes, water
pipes, telephone, lightening rods or other grounding wires.
Improper grounding may cause electric shock.
Electric Wiring must be done by professionals. Use a
separate circuit according to national regulations.
If the wiring capacity is not enough, electric shock or fire may
occur.
CAUTION
1. Be sure to Install Current Leakage Protection Switch, Or
electric shock may occur.
2. Power cord is to be selected according to national regula-
tions.
3. an all-pole disconnection device which has at least 3mm
separation distance in all pole and a residual current
device(RCD)with the rating of above 10mA shall be incorpo-
rated in the fixed wiring according to the national rule.
4. Outdoor unit power cord should be selected and connected
according to the outdoor unit installation manual.
5. Wiring should be away from high temperature components,
or the insulation layer of the wires may melt down.
6. Use wire clamp to fix the wires and terminal block after
connection.
7. Control wire should be wrapped together with heat insulated
refrigerant pipes.
8. Connect the indoor unit to power only after the refrigerant
has been vacuumed.
9. Don’t connect the power wire to the signal wire connection
end.
7.1 The specification of power
Table 7-1
MODEL (W)
2200-14000W
1-PHASE
Power
Phase
Frequency
& volt
Circuit breaker/fuse (A)
Indoor/outdoor
connecting wire
(mm
2
)
Ground
wiring(mm
2
)
Weak electric
signal
5/3
2.0
3x0.75
220V~ 50Hz
CAUTION
A disconnection device having an air gap contact separation
in all active conductors should be incorporated in the fixed
wiring according to the National Wiring Regulation.
CENTRAL CONTROL
MONITOR(CCM)
INDOOR UNIT
OUTDOOR UNI T
COMPUTER
INDOOR UNIT
INDOOR UNIT
3x0.75mm2 (Shielded)
Power (220V~ 50Hz/60Hz)
CAUTION
The reserved function is indicated in broken line table,users
can select it when necessary
7.2 Indoor/outdoor unit signal wire
Connect the wire according to their numbers.
Wrong connection may cause malfunction .
7.3 Wiring connection
Seal the wiring connection with the insulation material , or the
condensing dew will be caused.
7.4 Panel Wiring
7.5 Terminal Board Diagram
Please refer to the indoor unit wiring diagram for the wiring.
Note: The air-conditioners can connect with Central Control
Monitor (CCM). Before operation, please wiring correctly and
set system address and network address of indoor units.
Connect the Swing Motor terminal block according to the
Panel Installation Manual.
Fig. 7-1
To indoor power
220-240V~ 50Hz
L
N
Fig. 7-2
Installation manual
7
Ceiling Floor
