Fig.3-1
Never throw or beat the controller.
Before installation, operate the remote controller
to determine its location in a reception range.
Keep the remote controller at least 1m apart from
the nearest TV set or stereo equipment. (it is
necessary to prevent image disturbances or
noise interferences.)
Do not install the remote controller in a place
exposed to direct sunlight or close to a heating
source, such as a stove.
Note that the positive and negative poles are
right positions when loading batteries.
Remote
controller
Remote controller
holder
Mounting screw B
ST2.9x10-C-H
CAUTION
Fig. 4-5
J. Connecting point of
refrigerant pipe
(I. gas side)
I. Connecting point of
refrigerant pipe
(J. Liquid side)
Drain point
Fig.4-1
Fig.4-2
Fig.4-3
Fig.4-4
WOODEN CONSTRUCTION
NEW CONCRETE BRICKS
FOR ORIGINAL CONCRETE BRICKS
Steel bar
Embedding screw bolt
(Pipe hanging and embedding screw bolt)
(Blade shape
insertion)
(Slide insertion)
Roof beam
Hanging screw bolts
Ceiling
Timber over the beam
Put the square timber traversely overthe roof beam, then install
the hanging screw bolts.
Inlaying or embedding the screw bolts.
Install the hanging hook with expansible bolt into the concrete
deep to 45~50mm to prevent loose.
4. INDOOR UNIT INSTALLATION
4.2 Wall Mounting Installation
NOTE
This manual is subject to changes due to technological
improvement without further notices.
4.1 The units may be mounted vertically, provided that
the correct clearances for positioning are maintained.
(Refer to Fig. 4-1 )
Installation manual
3
Ceiling Floor
