mundoclima CL20007, Инструкция по установке и эксплуатации

Страница: 37 / 84

To save of a service call, please try the suggestions below to see if
you can solve your problem without outside help.
the cost
Causes
Solutions
●
The power switch is released.
●
Power supply failure.
●
The fuse is burnt.
●
It doesn't reach the setting time for
starting up.
■
Switch on the power.
■
Wait for the recovery of power supply.
■
Replace the fuse.
■
Wait or eliminate the original setting.
Causes
Solutions
Unit Doesn't Start When Pressing ON/OFF Button
●
It is not three minutes after switch off.
●
Room temperature is lower than the
setting temperature.
■
Wait three minutes.
■
Reset the temperature.
Troubleshooting
Air Condition Will Not Operate
2.Wipe the unit with dry cloth .
3.If the unit is very dirty, please wipe with
wet cloth dipped by cold water .
※ Never use hot water over 40 (104 )to clean the air filter. ℃ ℉
※ Do not use gasoline ,benzene ,thinner or any other chemicals, or any liquid
insecticide on the air conditioner, as these substances may cause flaking off of
the paint ,cracking or deformation of plastic parts .
※ Never attempt to clean the unit by pouring water directly over any of the
surface areas, as this will cause deterioration of electrical components and
wiring insulation.
Note: if you don’ t use the unit for a long
please pull out the rubber plug to drain
the inside water out referring to right figure.
time,
air conditioner and cut off the power supply .
1.For the purpose of safety, please turn off the
Cleaning The Unit
WARNING
37