Multiva Cerex 300 Comfort, Руководство по эксплуатации и обслуживанию

Страница: 144 / 187

5. Dry the hopper with pressurised air.
6. Close the bottom ap of the feeder unit.
7.3.3. Cleaning the paint surface
Wear protective goggles and protective gloves when cleaning the paint surface.
Clean the paint surface at the end of the seeding season.
1. Clean the seed drill’s paint surface by brushing and using pressurised air.
2. If needed, clean the paint surface with pressure washer.
CAUTION
Do not allow water to enter electrical instruments.
3. Lubricate all lubrication points in accordance with section 7.2. Lubrication.
Damaged paint can be touched up after washing. The painted surface can be protected
with a light application of oil, using protective oil intended for the purpose. Entry of
protective oil on rubber and plastic parts should be avoided.
7.3.4. Cleaning the coulter discs
Wear protective goggles and protective gloves when cleaning the discs of the coulters.
Figure. 7.3.4. - 192. Coulter discs
1. Clean the discs (1) of the coulters with a pressure washer.
Clean the clearance between the scraper and covering wheel as well.
2. Apply protective oil on wear parts to protect them from corrosion.
3. Once the discs are dry, turn each pair of coulter discs a few turns so that the scrapers
remove the dry dirt from the inside of the discs.
Operation and maintenance manual
Cerex 300 and Cerex 400 Comfort
1.00
144 (187)