Multitone FLA 872, Техническое руководство

Страница: 48 / 86

TLA 852/FLA 872
TM1205 Issue 2 Page 5 - 8
5.6.3 LCD Module Installation
a) Use the Anti-static Workstation and the correct soldering tools to connect the
flexible cable to the Decoder Board.
b) Carefully fold the flexible cable and install the two pins on the rear of the
module in the holes on the Decoder Board.
5.6.4 Board Assembly
a) Make sure that the Rubber Mat is correctly installed on the Radio Board.
b) Put the Decoder Board on the Rubber Mat. Make sure that the four small
extensions at the rear of the LED Module are located under the aerial.
c) Align SKT1 with PL401 and carefully press the two boards together until the
connectors are fully connected.
5.6.5 Board Assembly Installation
a) Slide the Board Assembly into the Case Back.
b) Make sure that the Battery Connector ‘fingers’ are in the correct position
under the Decoder Board.
c) Push down on the front edge of the board and slide the board under the
small extensions on the Case Back.
d) Push the rear edge of the Board Assembly into the Case Back.
5.6.6 Case Assembly
a) Install the Case Front on the Case Back by applying pressure to the sides of
the case and pushing the rear edges of the case together until the catches
snap in place.
b) Install the two 2.2mm x 6mm screws in the Case Back.
c) Open the Battery Door and install the battery.
d) Close the Battery Door and push it towards the top of the unit until it locks.