Multitech RF802, Руководство пользователя

Страница: 10 / 58

Chapter 1 - Introduction
Multi-Tech Systems, Inc. Wireless Network Adapter User Guide 10
Setup 4 – The Home Internet Network with a Residential Gateway, Firewall,
or Router
Use This Setup If:
You have two or more computers and/or laptops and want to share files, printers,
and Internet access using a Residential Gateway, Router, or Firewall
Or
You want to connect to an Ethernet network that uses Dynamic (DHCP) IP addresses.
This setup requires a 1) a Wireless Router or an Access Point and 2) an Ethernet
capable Gateway, Router, or Firewall or an existing Ethernet network.
Additional Requirements:
These setup directions are intended for Network Administrators with Dynamic IPs.
This type of setup requires that your residential Gateway, Router, Firewall, or
Network Administrator give you a dynamic IP address for each computer.
You will also have to setup your Access Point. Consult Access Point documentation its
installation procedures.
Steps:
1. Using the Ethernet cable provided with your router, connect the router to the
Cable/DSLmodem.
2. Connect the Access Point to the Router.
3. Install the Wireless Network Adapter - See the Installation section of this
guide or the Quick Start Guide.
4. Check the wireless connection - See Configuration Utility and Networking
Basics.
5. Check the IP Address for the wireless adapter - See Networking Basics.
Note: The default settings for the Wireless Network Adapter are set to obtain
a Dynamic IP Address.
6. Learn to share printers and files - See Networking Basics.
PC with wireless
connection
to another PC
Cable Modem
MT202TD
PC with wireless USB Adapter
“connected” to an access point
Wireless
Access Point
LINE
LINE LINE
Broadband
Gateway
The Home Internet Network with a Residential Gateway, Firewall, or Router