Multi-Tech Systems, Inc. MultiConnect AW User Guide
15
Account Activation – MT100A2W-G Only
Check the Multi-Tech website at
www.multitech.com/activation.go
for account activation information.
Choose
Generic GSM Activation
and follow the directions to activate your account.
Insert the SIM Card into Holder, if Required
To operate the MultiConnect, you need a power supply connection. For the MT100A2W-G model, you
also need to insert a SIM card (Subscriber Identity Module) to operate the MultiConnect on a GPRS/GSM
network.
To install the SIM card:
Caution:
Disconnect the power supply before adding or changing a SIM card.
1.
Use a small Phillips screwdriver to remove the two SIM door screws and remove the SIM door.
2.
Insert the SIM card into the card holder. The graphic above shows the correct SIM card orientation.
3.
Verify that the SIM card fits into the holder properly and then replace the cover.
Connect the Antenna, Cables, and Power
MT100A2W-G
MT100A2W
1.
Connect a suitable antenna to the ANT connector on the MT100A2W-G model, (see
Antenna
Specifications
in Chapter 1).
2.
Connect the DE9 connector (9-pin) of the RS232 cable to the COMMAND connector on the unit and
connect the other end to serial port on your PC.
3.
For the MT100A2W model, connect an RS232 cable, male connector, to the MODEM connector on
the back of the unit. Connect the other end of the cable to your external wireless modem.
