Multitech CC1600 Series, Руководство пользователя

Страница: 40 / 76

40
MT2834BLR Owner’s Manual
COMMAND: #Tn
VALUES: n = 0 or 1
DEFAULT: #T1
DESCRIPTION: #T0 turns off Trellis Coded Modulation
#T1 turns on Trellis Coded Modulation
COMMAND: Un
VALUES: n = 0, 1, 2, or 3
DEFAULT: n/a
DESCRIPTION: U0 places modem in Analog Loop Originate Mode.
U1 places modem in Analog Loop Answer Mode.
U2 places modem in Remote Digital Loopback test mode.
U3 places modem in Local Digital Loopback Test Mode.
COMMAND: Vn
VALUES: n = 0 or 1
DEFAULT: V1
DESCRIPTION: V0 means Result Codes sent as digits(terse response).
V1 means Result Codes sent as words (verbose response).
COMMAND: #Vn
VALUES: n = 0 or 1
DEFAULT: #V1
DESCRIPTION: User can bypass V.32terbo handshaking process.
#V0 means V.32terbo enabled in originate/answer mode.
#V1 means V.32terbo disabled in originate/answer mode.
COMMAND: W
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: Wait for new dial-tone.
COMMAND: &Wn
VALUES: n = 0 or 1
DEFAULT: &W1
DESCRIPTION: &W0 causes modem to store its current parameters in nonvolatile
RAM, and modem will load these for future sessions instead of
reading factory ROM defaults, unless &F command used.
&W1 causes modem to not store parameters.
COMMAND: Xn
VALUES: n = 0, 1, 2, 3 or 4
DEFAULT: X0
DESCRIPTION: X0 selects Basic Result Codes (w/o CONNECT 1200,
CONNECT 2400).
X1 selects Extended Result Codes (w/CONNECT 1200,CONNECT
2400).
X2 selects Standard AT Command set with NO DIALTONE.
X3 selects Standard AT Command set with BUSY.
X4 selects Standard AT Command set with NO DIALTONE and
BUSY.