MULTIQUIP V305EH, Руководство по эксплуатации и запасным частям

Страница: 26 / 102

PAGE 26 — V305EH VIBRATORY ROLLER • OPERATION AND PARTS MANUAL — REV. #1 (06/21/16)
MAINTENANCE
INSPECTION AND MAINTENANCE SERVICE TABLES
To make sure your vibratory roller is always in good
working condition before using, carry out the maintenance
inspection procedures.
CAUTION
Inspection and other services should always be carried
out on hard and level ground with the engine shutdown.
Table 5. Machine Inspection
ITEM HOURS OF OPERATION
Loose or Missing Screws Every 8 hours (every day)
Damaged Parts Every 8 hours (every day)
Function of Controlling
System Part
Every 8 hours (every day)
Eaton Hydrostatic
Transmission
Every 100 hours
Vibrator Oil Check Every 50 hours
V-belt (clutch) Check Every 200 hours
NOTICE
These inspection intervals are for operation under
normal conditions. Adjust your inspection intervals
based on the number of hours the roller is in use, and
your particular working conditions.
Table 6. Engine Check
ITEM HOURS OF OPERATION
Oil or Fuel Leak Every 8 hours (every day)
Tightness of Fastening
Threads
Every 8 hours (every day)
Engine Oil Check and
Replenishment
Every 8 hours (every day)
(Replenish to specified
maximum level)
Engine Oil Replacement
After first 25 hours then
every 50 to 100 hours
Air Filter Cleaning Every 50 hours
DAILY SERVICE
1. Check for leakage of fuel or oil.
2. Check for loose screws and tighten to the proper
torque:
SPARK PLUG
1. Remove and clean the spark plug (Figure 31).
2. Adjust the spark gap to 0.024 ~0.028 inch (0.6~0.7
mm). This unit has electronic ignition, which requires
no adjustments.
Figure 31. Spark Plug Gap
ENGINE OIL
1. Drain the engine oil when the oil is warm as shown in
Figure 32.
2. Remove the oil drain bolt and sealing washer and allow
the oil to drain into a suitable container.
3. Replace engine oil with recommended type oil as listed
in Table 4. Engine oil capacity is 1.16 quarts (1.1 liters).
DO NOT
overfill.
4. Install drain bolt with sealing washer and tighten
securely.
Figure 32. Engine Oil (Draining)
0.024-0.028 IN.
(0.6-0.7 MM.)
GAP
OIL FILLER CAP
DIPSTICK
DRAIN
BOLT
SEALING
WASHER