MULTIQUIP V305EH, Руководство по эксплуатации и запасным частям

Страница: 18 / 102

PAGE 18 — V305EH VIBRATORY ROLLER • OPERATION AND PARTS MANUAL — REV. #1 (06/21/16)
COMPONENTS
Figure 7. V305EH Additional Components
Figure 7 shows the location of additional components
for the V305EH compaction roller. The function of each
component or control is described below:
1.
Vibration Drive V-Belt
— This belt is require to make
the roller vibrate. Check this V-belt as outlined in the
maintenance section of this manual.
2. Free Wheel Engagement Lever — Under normal
conditions this lever should be place in the
forward
position (engaged).
In the event the roller becomes disabled (will not start)
and must be moved, place the lever in the side position
(disengaged). This will allow the roller drum to rotate
(free wheel).
IMPORTANT:
This lever is only to be used in cases
where the roller has be disabled. In normal operating
conditions this lever should be left in the engaged
position (forward).
1
3
2
6
4 5
7
3. Travel Drive V-Belt — This belt is require to make the
roller travel in a forward or reverse direction. Check
this V-belt as outlined in the maintenance section of
this manual.
4.
Compartment Hood
— Open this hood (tool-free) to
gain access to the V-belts, hydrostatic pump, coupling
components, free wheel engagement lever etc.
5.
Hydrostatic Pump
— Provides hydraulic pressure to
the drive system.
6.
Hydrostatic Fluid Reservoir
— Fill this reservoir with
hydrostatic transmission fluid. Fill with ExxonMobil
Nuto 46 or equivalent.
7. Cogged-Drive Belt — This belt is used with the
hydraulic pump. Check this cogged drive belt as
outlined in the maintenance section of this manual.