MULTIQUIP V305EH, Руководство по эксплуатации и запасным частям

Страница: 15 / 102

V305EH VIBRATORY ROLLER • OPERATION AND PARTS MANUAL — REV. #1 (06/21/16) — PAGE 15
OPERATING ON SLOPES
Special care must be taken when operating the roller on
hills or slopes. There exist the possibility of serious injury to
the operator and severe damage to the roller in the event
of a roll over.
ALWAYS
operate the roller up and down hills
rather than from side to side. For safe operation, hillside
slopes should not exceed 6° (10% grade). See Figure 3
below.
Figure 3. Recommended Slope
CAUTION
NEVER
stand under, or get onto the roller while it is
being lifted or moved.
NOTICE
ONLY
use steel ropes or chains that are capable of
lifting at least 2,000 lbs (907 kg).
NEVER
use any other part of the roller for lifting
purposes. Use the lifting eye. Using other parts of the
roller for lifting will cause severe damage to the roller.
10%
MAXIMUM SLOPE
GENERAL INFORMATION
Tipping (Rollovers)
NEVER
operate the roller on side slopes (Figure 4). The
possibility exists of the roller tipping over (roll over), thus
causing bodily harm even death and serious damage to
the equipment.
Figure 4. Tipping (Rollover)
In the event the roller does tip over, extreme care must be
taken to prevent damage to the engine. When the roller has
been tipped over, oil from the engine crankcase can flow
into the combustion chamber, which can severely damage
the engine the next time it is started.
IMMEDIATELY
after a unit has tipped over upright the unit
as soon as possible to prevent oil from leaking into the
combustion chamber.
SIDE TO SIDE
OPERATION
NOT RECOMMENDED
ROLL OVER
NOTICE
To prevent damage to the engine after a rollover, the
unit must NOT be started. NEVER start a unit after a
rollover. CONTACT your nearest authorized Multiquip
dealer for instructions or servicing.
CAUTION
NEVER operate the roller on side slopes . The roller
may tip over causing injury to personnel and severe
damage to the equipment.