INSTALLATION/OPERATION MANUAL — REV. #0 (09/09/09) — PAGE 13
CABLE INSTALLATION
Data Cable Connections
Wire data cable into control box as shown in Figure 6.
1.
Splice RED wire labeled BATT+. and connect to relay K1, pin 30 (12
2.
volt key switch ON).
Disconnect engine fuel solenoid BLACK ground wire from the control
3.
panel support bracket. Leave 1.5-inches of wire on control box side.
Splice the WHITE wire labeled EMERGENCY STOP with the BLACK
4.
ground wire that was removed from the control panel support bracket.
Crimp a #16-14 (5/16”) terminal ring onto the BLACK wire labeled FRAME
5.
GROUND. Connect this end of the wire to engine chassis ground.
Insert connector end of data cable into Miratron receiver.
6.
Remote Control Cable Connections
Insert yellow remote control cable (Figure 6) into the 2-pin receptacle
1.
labled REMOTE OUTLET on the control box.
Secure yellow remote cable with pressed on tie-wrap pads to side of
2.
control box as shown in Figure 6.
Wire remote control cable to the control box as shown in Figure 6.
3.
Splice the WHITE wire labeled REMOTE (data cable) with the BLACK
4.
wire from the yellow remote cable
Splice the WHITE wire labeled NO PUMP ON with the WHITE wire from
5.
the yellow remote cable.
Re-install control box using the existing mounting hardware.
6.
Re-install air fi lter
7.
Reconnect negative battery cable to battery.
8.
