Confidential
Page 6
Touchscreen Display (Continued)
The button labeled “SETUP” is used to enter the setup screen shown below.
Setup Screen
A description of each varaible in the setup screen is listed below:
VER:
Firmware version number and revision letter
SENSE:
Raw sensor magnitude (unitless)
LEVEL:
Raw excitation level used only for diagnostics (unitless)
FREQ:
Primary frequency setting used only for diagnostics (unitless)
G_TEMP:
Temperature of controller (Celsius)
S_TEMP:
Temperature inside sensor (Celsius)
STATUS:
See description of serial command “XS”. (16 bit hex)
BAUD:
Host serial port baud rate (bps)
To change the baud rate, press the screen where the baud number is displayed and the screen
will change to a keypad. Use the “C” button to clear the value and then enter the new desired
baud rate and press the green “ENTER” button. Or, if you do not want to change the value, you
may cancel your changes and exit the keypad by pressing the red “X” button.
To exit the setup screen and return to the main screen, press the “OK” button.
