Multikomplex SLT973, Инструкция по установке, использованию и обслуживанию

Страница: 32 / 50

32
For the installation of the product in lamp version it
is necessary to create a plasterboard lowering, ke-
eping at least 100mm distance between the same
and the solid ceiling.
A circular opening must be made in the plasterbo-
ard, with dimensions equal to: 510mm (fig. 4)
Make a metal or wooden structure on which to fix
the product; consider the fixing holes indicated in
fig. 17.
In addition to what is indicated above, proceed
with the installation as for the hood product, indi-
cated in the previous chapter.
33
LAMP VERSION
INSTALLATION
Remove the product from its packaging and place
it on a suitable surface: we suggest using a soft
material, such as a sponge or a cloth.
Open the panel as shown in Fig. 1 and described
in the previous paragraph, remove the grease filter
using the handle.
Using a suitable tool, remove the eight screws
securing the outer frame and then remove it as
shown in Fig. 20.
Also disconnect the flat cable and the electrical ca
ble of the reset button.
Install the upper part of the product in the plaster
board niche, the three slots must coincide with the
threaded rods previously installed, as shown in fig.
21.
Bring the product to a stop with the washers pre
viously positioned.
Secure the product with three washers and three
nuts supplied. (fig. 22)
Connect the air outlet duct and the power supply.
Remove the LED ceiling light from its packaging
and run the cables through the three holes in the
frame (fig. 14).
Adjust the desired height of the LED ceiling light to
the floor using the cable clamp as shown in fig. 15.
Move the frame closer to the plasterboard niche,
then restore the previously removed electrical con
nections and make the electrical connection of the
LED ceiling light, taking care not to confuse the
positive, negative and ground polarities indicated
by the labels in the electrical cables.
Lock the niche to the product previously fixed with
the eight screws previously removed, fig. 16.
Restore the grease filter and the metal panel fixed
with special magnets.