16
6. How to Use the Waveform Generator
(MP720781 & MP720783 only)
The instrument can provide 4 basic waveforms, sine wave, square wave,
ramp wave, pulse wave, and 8 arbitrary waveforms.
Connect the output
Press the
Mode
button to switch the instrument interface to the waveform
generator function interface.
Please note if the upper left corner of the screen
is ON/OFF. If it is OFF, press the run / stop button to switch.
Connect the BNC cable to the port marked
GEN Out
in the top of the
oscilloscope.
Generator Output Ports
To observe the output of the waveform generator, connect the other end of
the BNC cable to the signal input connector of the oscilloscope.
Set the waveform
(1) Press the
Mode
button to switch the instrument interface to the waveform
generator function interface.
(2) Select the desired waveform from the menu items below, and the screen
will display the corresponding waveform setting menu.
(3) Set the parameters of the desired waveform through the operation panel
F1-F4 or the up, down, left, and right panel keys.
