Page <8>
V1.0
14/06/22
Newark.com/multicomp-pro
Farnell.com/multicomp-pro
sg.element14.com/b/multicomp-pro
Important Notice :
This data sheet and its contents (the “Information”) belong to the members of the AVNET group of companies (the “Group”) or are licensed to it. No licence is granted for
the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change
without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness,
any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make
any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or
where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its
negligence. Multicomp Pro is the registered trademark of Premier Farnell Limited 2019.
Command code & Return Value
Description
Example
Input Command: GISH [CR]
Return Value: <Current>[CR][OK][CR]
Get current set high limit
<Current>=????
Input Command: GISH [CR]
Return Value: 5500 [CR][OK][CR]
Meaning: Current set high limit is 5.500A
Input Command: GISL [CR]
Return Value: <Current>[CR][OK][CR]
Get current set low limit
<Current>=???
Input Command: GISL [CR]
Return Value: 250 [CR][OK][CR]
Meaning: Current set low limit is 0.250A
Input Command: GMAX [CR]
Return Value: <Voltage><;><Current><;>[CR]
[OK][CR]
Get voltage set high limit &
current set high limit
<voltage> =????
<current> =????
Input Command: GMAX [CR]
Return Value: 3600;5500;[CR][OK][CR]
Meaning: Voltage set high limit is 36.00V
& Current set high limit is 5.500A
Input Command: GMIN [CR]
Return Value: <Voltage><;><Current><;>[CR]
[OK][CR]
Get voltage set low limit & cur-
rent set low limit
<voltage> =???
<current> =???
Input Command: GMIN [CR]
Return Value: 100;250;[CR][OK][CR]
Meaning: Voltage set low limit is 1.00V &
Current set low limit is 0.250A
