Page <4>
V1.0
14/06/22
Newark.com/multicomp-pro
Farnell.com/multicomp-pro
sg.element14.com/b/multicomp-pro
7. Turn on the output terminal again and check if display shows (CV).
8. If display shows (CC), either your preset current limiting value is too low or your load requires more voltage and current.
You need to re-access the voltage and current requirement of your load and increase the voltage or current accordingly
until (CV) appears.
Connecting the 3 outputs
(using NTP -6531, 1-36V, 0.25-3A as an example)
All the three outputs are fully isolated from ground and with each other so that it is possible to make cross connections to power
a circuit board or device that requires for example: +3 or +5V, +12 V or -12V and 1-36V as shown in Fig.1.
The variable main output is set for 12V and it is assigned as the +12V source (available maximum current 3A)
Note the variable main output can be set for other voltage (1-36V) such as 16V.
The fixed 12V is made as the - 12V source (available maximum current 0.5A)
The fixed 5V is made as the +5V source. (available maximum current 0.5A)
Connecting outputs in series
(using NTP-6531 as an example)
You can have a 17V fixed output by connecting the 5V in series with the 12V outputs.
The 2 outputs (Aux.1) can be connected in series to make a variable 5V to 41V with maximum current 2A (Fig. 2)
The 3 outputs can be connected in series to make a variable 17V to 53V with maximum current 1A, (Fig. 3)
There are other combination of cross connections for different positive and negative output voltages.
