MULTI-MOVER XL75
15
By rotating the drive switch (6) to the front with your thumb, the driving direction will first be
switched on and then, when rotated further, the Multi-Mover XL75 will start to drive. The central
position is the neutral position.
By rotating it downwards, the Multi-Mover XL75 will reverse.
Caution! Only switch to forward or reverse if the Multi-Mover XL75 is standing still.
Ignition lock (1.9)
The ignition lock (9 fig. 1) is used to switch off the batteries,
aways switch off the battery in case of
maintenance to the Multi-Mover XL75.
5.4
Battery charger connection and Batteries (1.1)
The batteries are filled with lead acid and sealed. They are fully sealed and maintenance free.
It is not possible to refill with distilled water. Press the Emergency Button (6) before charging.
Battery charger connection
The connection plug for the battery charger is located on the right side, in a recess of the encasing.
On the dashboard of the Multi-Mover XL75, the battery indicator (8) is placed. If the BDI (Battery
discharge Index) is below 30% maximum speed is reduced to 50%, this to prevent damage to the
batteries. Make sure you charge right away. BDI 100 % means full charged
If the Multi-Mover XL75 is out of operation (for a longer period), we recommend keeping the battery
charger connected, it will automatically keep the battery in a charged condition.
Charging location
The charging location must be well ventilated, because very explosive gases (detonating gas) are con-
tinuously released during charging.
Avoid open fire or sparks at the charging location while charging. During charging, an explosive gas
may be released.
The battery charger (# optional) operates fully automatically, i.e. the charger is equipped with an
electronic system that will check the charging status and act accordingly.
Check whether the supply voltage to the battery charger corresponds with the voltage stated on the
battery charger.
Some instructions for battery use and maintenance.
Charging
1 Insert the plug of the battery charger into the connection on the encasing and connect the battery
charger to the mains.
2 In the second phase, the automatic battery charger will charge all elements at maximum voltage
in the final phase the battery charger will stop.
The battery charger will switch off automatically.
Premature wear of the battery
If the batteries are used incorrectly, it is possible that they wear quickly. Premature wear is not an
error in production and is therefore not within the scope of the warranty arrangement.
