Mod. 6609-12d: Automatic Forms Cutter
31.05.2006
-8-
7. Adjusting the paper guide (on the pneumatic
spring)
When the plexiglass cover is closed, the paper guide
should
be about 1 to 1.5 mm from the center bearing block. Remove the
screw
to move the device for holding down paper
onto the
gas cylinder
. Be very careful when making this adjustment
since this directly affects the correct positioning of the paper on
the edge of the cross cutter.
Be sure not to accidentally cover the fibre-optic sensor for
determining paper end with the device for holding down paper.
Otherwise, the automatic cutter will continue to run once the end
of the paper has been reached and run in reverse when the
machine is started.
8. Adjusting
the
fibre-optic
sensor for
determining paper end
Remove the tie-bar and tractor according to the instructions in 2.
Unscrew the tie-bar holder
. Remove the screw on the side
and vertically move the sensor head
. The sensor head should
have a clearance of 0.3 mm.
9. Removing the tractor shaft
Take out the flat belt. Insert the lever tool-nr. 15336
in the belt
pulley
. Lift the locking pin
and, at the same time, pull out the
tractor shaft in an axial direction.
When reinstalling the tractor shaft, make sure that the locking pin
"clicks" into place in the shaft.
Содержание 6609d
Страница 1: ...Service Instructions Automatic Forms Cutter Modell 6609d 6612d Stand 31 05 2006 ...
Страница 4: ...Mod 6609 12d Automatic Forms Cutter 31 05 2006 4 ...
Страница 19: ...Mod 6609 12d Automatic Forms Cutter 31 05 2006 19 ...
Страница 22: ...Mod 6609 12d Automatic Forms Cutter 31 05 2006 22 Measurement Points PC Board ...
