Assembly instructions
Installing the main bar on the roof
3
V4.20180614
9
2.
- Position the angle bracket and re-tighten the screws.
3.
Make sure that the screws are sealed after tightening.
4.
Center the main bar on the angle brackets. The main bar may not protrude over
the edge of the roof. Please note that the connection for the GPS receiver must
face the rear.
5.
Attach the main bar firmly with the supplied screws.
Installation with additional components
Proceed as follows if the additional angle bracket is used with the additional
components.
There is no GPS receiver on the tractor roof.
1.
- Look for the screw fasteners above the
doors.
2.
- Screw the additional angle bracket using the spacer
sleeves onto the screw fasteners above the doors.
3.
Center the main bar on the additional angle brackets. The main bar may not
protrude over the edge of the roof. Please note that the connection for the GPS
receiver must face the rear.
4.
- Install the
adjustable feet between the main bar and the tractor roof to prevent vibrations.
5.
Screw on the main bar firmly.
3.2.2
Procedure
