TROUBLESHOOTING
Problems
Possible Cause
Possible Solution
Machine
refuses to
start
Fluctuating
pressure
Machine
stops
Machine
pulsating
Fuse blows
The machine is not plugged-in Plug the machine in
Try another receptacle
Faulty receptacle
The fuse has blown
Unplug other appliances.
Replace the fuse
Faulty extension cable
Try without the extension cable
The pump is drawing in air
Check that hoses and connections
are airtight
Valves dirty, worn or sticking
Contact authorized service representative
Contact authorized service representative
Increase water pressure, check for
blockage and/or change the water
supply outlet
The water supply is not
sufficient
Pump seals worn
The fuse has blown
Replace the fuse
Unplug other appliances. Check that
the main voltage corresponds to the
specifications on the rating label
Incorrect mains voltage
Fuse too small
Increase in the amperage
Thermal sensor activated
Leave the machine to cool for 5 mins
Clean the nozzle with a needle and
by spraying water rearwardly
through the jet
Replace it with a fuse with higher
amp consumption than the washer
Allow machine to run with open
trigger until regular working
pressure resumes
Increase water pressure, check for
blockage and/or change the water
supply outlet
Clean the nozzle with a needle and
by spraying water rearwardly
through the jet
Try without the extension cable
Air in inlet hose / pump
Inadequate supply of water
generated
Partially blocked jet
Water filter blocked
Clean the filter
Folded pipe
Unfold the hose
Partially blocked jet
16
