Muddy the Liberty MTP3000, Инструкция по эксплуатации

Страница: 10 / 16

ATTENTION!!
WHEN YOU SEE A “ WARNING!” BE SURE TO HEED THE MESSAGE!
THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!!
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
This instruction manual complies with the ASTM standard F2123 - Standard Practice for Treestand Instructions.
10
STEP 11.
Lay the assembled top section down with the
front up (“the front” is the side where the ladder sections
will be attached—see Fig. 6/pg. 8). Attach the top legs to
the standing platform using (4) 5/16’’ x 3 1/4’’ hex bolts
[H], (8) nylon washers and (4) 5/16’’ nylock nuts. Then
connect the
middle legs
to the
top legs
and the
bottom
legs
to the
middle legs
using (4) 5/16’’ x 2 1/4’’ hex bolts
[F], (8) nylon washers and (4) 5/16’’ nylock nuts to secure.
Insert the adjuster legs into the bottom legs and secure
at desired height using (2) snap pins (Fig. 5). NOTE: Make
certain the snap pins are engaged and the “wire keeper” is
secured, see snap pin illustration below.
Top Leg Top Leg
Standing
Platform
H
H
H
F
F
Middle Leg
Middle Leg
Bottom Leg
Bottom Leg
F
Adjuster Leg
Adjuster Leg
Snap Pin
Snap Pin
F
H
FIG. 7
SNAP PIN ILLUSTRATION
Wrap snap pin closure around
front of tubing and secure
over end of pin.